Packet capture on Cisco ASA

using the CLI to do packet captures on a cisco ASA #sh cap     (see if any captures are currently running) #cap <name of capture> interface <nameif inside> match ip host <scource IP> host <destination IP> #cap <name of capture> interface <nameif inside> match ip host <scource IP> any #cap […]

Cisco Password Recovery Steps and Break Sequence

Standard Break Key Combinations Software Platform Operating System Try This Hyperterminal IBM Compatible Windows XP Ctrl-Break Hyperterminal IBM Compatible Windows 2000 Ctrl-Break Hyperterminal IBM Compatible Windows 98 Ctrl-Break Hyperterminal (version 595160) IBM Compatible Windows 95 Ctrl-F6-Break Kermit Sun Workstation UNIX Ctrl-\l Ctrl-\b MicroPhone Pro IBM Compatible Windows Ctrl-Break Minicom IBM […]

Sonicwall HA Stateful and Non-Stateful High Availability Prerequisites

Stateful and Non-Stateful High Availability Prerequisites Resolution Stateful and Non-Stateful High Availability Prerequisites • The Primary and Backup appliances must be the same model. Mixing and matching SonicWalls of different hardware types is not currently supported. • It is mandatory that the Primary and Backup appliances run the same version of SonicOS […]

Sonicwall Adding HA Pair to GMS

Description Adding High Availability Pair to GMS Resolution Feature: This article describes the procedure how to properly add HA Pair to GMS. NOTE: For HA Pair only Primary unit should be added to GMS. GMS sees HA Pair as one logical unit and if primary fails backup is sending SYSLOG to […]

Sonicwall HA Pair Active/Standby Configuration

How to Configure High Availability (HA) Description This article explains how to configure High Availability on 2 SonicWall Appliances.  CAUTION: HA does not support Portshield interfaces and Native Bridge mode.   The LAN (X0) interfaces are connected to a switch on the LAN network. The WAN (X1) interfaces are connected to […]

Sonicwall HA Pair Active/Active Configuration

Configuration: Source: http://help.sonicwall.com/help/sw/por/6950/26/2/4/content/HA_AAClusteringConfig.html Configuring Active/Active Clustering • Configuring Active/Active Clustering High Availability • Configuring Active/Active Clustering High Availability Monitoring • Configuring Active/Active DPI Clustering High Availability • Configuring VPN and NAT with Active/Active Clustering Configuring Active/Active Clustering High Availability Active/Active Clustering High Availability allows for the configuration of up to four […]